If its leaking on the final rinse then its usually down to a clogged water softner section.
You need to remove the soap drawer and take the softner cover off and give this a good clean out. Make sure the drawer is all clear in there.
Then refit it and retry the washer again and fingers crossed this should cure the fault.
Let me know how it goes.
I've already cleaned out the softer insert and run washer again, but it still leaked. Incidentally I have found a small (around 7cm long) 'J' shaped plastic piece, shaped as a small trough, in the Drawer area, it was right at the back of the opening when I removed the dispenser. Has this become detached from somewhere?
Is it only leaking as its filling up?
Also dont suppose you can post a picture of the part you have found?
Attachments are only available to registered users.
I cannot picture what they are off?
Have you tryed the washer since?
If so is it still leaking?
Does it take the softner?