The water in my AEG Favorit 43070Vi dishwasher doesn't heat up during any of the wash cycles.
I've been working hard to find a Professional to assist you with your question, but sometimes finding the right Professional can take a little longer than expected.
I wonder whether you're ok with continuing to wait for an answer. If you are, please let me know and I will continue my search. If not, feel free to let me know and I will cancel this question for you.
Yes please continue search.
We will continue to look for a Professional to assist you.
If you decide on a refund, or wish to keep the credit for a future question, then of course we'd honour it.
Thank you for your patience,
Sorry for the delay do you still need help on this?
If so is it still going through the cycle ok but just no heat?
Ok if its completeing the cycle but just not heating then its usually either a faulty heater or control board.
As its built in the first thing to check is the control board.
Remove the outer door panel and then you can remove the front plastic control panel.
From there take the control board out and take a picture of the wiring and then pull the wires off.
Then open the casing and remove the board and then inspect it. As you can sometimes get a burn mark or dry joint on the heater relay. If so then you can usually resolder it and that cures it.
But if the control board looks ok then you need to pull the dishwasher out and remove the right hand side panel. There at the bottom at the back you will see the heater. Its a silver cylinder.
With a multimeter you need to pull the wires off and then test the heater. It should give a reading of about 28 Ohms. If faulty then it will need to be replaced.
So cehck them 2 out and see what you find and let me know.