How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16371
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

dw600 leds all on, no response from machine at all. Have replaced

Customer Question

dw600 leds all on, no response from machine at all. Have replaced pcb, no difference!
Submitted: 3 years ago.
Category: Appliance
Expert:  Daniel replied 3 years ago.

Hi

 

Which pcb did you replace?

Was it the one on the left or the one with the leds on it?

 

Regards

Customer: replied 3 years ago.

display pcb p/n XXXXXXXXXX


located top left of dishwasher ( view from front)

Expert:  Daniel replied 3 years ago.

Hi

 

Ok try this and see what happens.

 

Turn the appliance off

Press and hold the program selector button and the start button.

Keep them held in and then turn the dishwasher on.

After about 5 seconds let go and all the leds should be flashing.

 

Then turn the machine off then turn it back on and see what happens.

 

Let me know how it goes.

 

Regards

Customer: replied 3 years ago.


All leds remain ON!

Expert:  Daniel replied 3 years ago.

Hi

 

Ok if that isn't doing anything then im afraid you are looking at a faulty main control board here im afraid.

 

If you remove the plastic control panel again the main board is on the left hand side opposite the display board. Replace that and this should cure the fault.

 

But to be honest most of the time if all the leds are lit its the display board at fault but the odd time it has been the main board so replace that and that should cure the fault here.

 

Regards

Customer: replied 3 years ago.

I will open up machine again tomorrow and check for main control board then get one ordered.

Expert:  Daniel replied 3 years ago.

Hi

 

Ok no worries just let me know how it goes.

 

Regards