How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Techdesk Your Own Question
Techdesk
Techdesk, Service Engineer
Category: Appliance
Satisfied Customers: 16409
Experience:  Whitegoods engineer working for a multibranded national company in the UK
13782322
Type Your Appliance Question Here...
Techdesk is online now

I have a New world Double oven - NW90DFDO and the fan oven

Resolved Question:

I have a New world Double oven - NW90DFDO and the fan oven has stopped working up to temperature the fan and oven light are working but the temperature wont go above 50 is this a thermostat problem and can I change it ?
Submitted: 3 years ago.
Category: Appliance
Expert:  Techdesk replied 3 years ago.
Hiya,
When you try the oven, the fan runs, does the temperature light on the front stay on too?

Thanks
Customer: replied 3 years ago.

yes

Expert:  Techdesk replied 3 years ago.
Hiya,
OK, thanks for that.
In that case, the most likely cause of the fault is the element has failed.

I'm advising on the most common cause of the problem you have.

Isolate the power to the appliance. Disconnect it from the electrical supply

The method of changing will depend on the element fitted at the time of manufacture.

There are 2 types, one is held from the front by screws, the other is held from the rear by nuts.

If the interior light is on the rear panel, take the light glass off first.

Take the rear panel inside the oven out.

This will reveal the element and the fan.

Take the screws holding the element in place out.

Bring the element and the wiring into the oven cavity.

(Be careful not to pull the wires off as you manouver the element into the cavity, if you do, you'll need to take the oven out, rear panel off to be able to retrieve the wires. Don't try the machine if you have lost a wire, retrieve it first).

If the element is not obviously blown, you need to test it with a multimeter to see if it's open circuit.

Swap the wiring on to the new element. (Don't lose the wires into the back or you'll need to take the appliance out and remove the panels to retrieve them).

Fit the element in place and replace the cover.

Turn the power back on and set the clock.
Try the oven again.

If there are no screws holding the element in place, take the cooker out and take the rear cover off.

You can now access the wiring and the nuts holding the element in place.

If the element tests ok, let me know.

Obviously, if you cannot do the work yourself, you'll need to get someone in to do it for you.

Hope this helps
Let me know how it goes or if you need more help
Thanks
Techdesk and other Appliance Specialists are ready to help you
Customer: replied 3 years ago.

it is the element.


 


many thanks for your advice

Expert:  Techdesk replied 3 years ago.
Hiya,
Thanks for letting me know.

Good luck with the repair.

Thanks

Related Appliance Questions