How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Michael Your Own Question
Michael
Michael, Customer Service
Category: Appliance
Satisfied Customers: 9568
Experience:  I have been an appliance repair tech for over 30 years and will help you solve your problems.
11519491
Type Your Appliance Question Here...
Michael is online now

I have a Pro Fittness treadmill, power light his on and lit

Resolved Question:

I have a Pro Fittness treadmill, power light his on and lit up but does not work. I have checked
that no wiring is loose. Could you please tell me what's wrong with it?
Submitted: 3 years ago.
Category: Appliance
Expert:  Michael replied 3 years ago.
Hello,
I am Tech Michael and I will be assisting you today.
Please be patient with us as these are technical questions and some testing may be required.
It may take a bit of back and forth conversation to be sure we have all the information in order to make a proper diagnosis.
May I have the full model #?
also did it fail while in use or just wouldn't rune one day when turned on?
Thank you
Tech Michael
Customer: replied 3 years ago.

Hi Micheal,
Pro fitness motorized treadmill with mp3 link jx-269


Just wouldn't run one day when I turned it on.


 

Expert:  Michael replied 3 years ago.
Thanks Maggie.
How old is your treadmill?
If all is ok with the wiring as is likely, the main driver board has failed.I have seen this many times.
Thank you
Tech Michael
Customer: replied 3 years ago.


Treadmill is about 3yrs old

Expert:  Michael replied 3 years ago.

Thank you Maggie,
One final question, did the unit smell like it a burning plastic smell at all before this happened?
Thank you for your patience.
Tech Michael
Customer: replied 3 years ago.


No smell just beeped and went off

Expert:  Michael replied 3 years ago.
Thank you Maggie,
this would be a failed motor driver, Its a circuit board in the unit.
This is easy to replace and I will help you calibrate it as well.
No soldering involved;-)
The best place to order this from is listed below. I will stick with you and help if you need my expertise But since this may take some time, if you will rate my service in a positive fashion thus far before you close this page, the system will allow me to schedule free follow ups with you and also ensure your question will NOT close or time out;-)
You will then be able to contact me at anytime at no additional cost until we have this fixed for you.
Thank you
Tech Michael here is the info you need Maggie:
toll free(NNN) NNN-NNNN
9:00AM-8:00PM Mon-Fri, ET


Michael and other Appliance Specialists are ready to help you