How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 15987
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

We have a Bosch Exxcel Multi Prog dishwasher. When the prog

Resolved Question:

We have a Bosch Exxcel Multi Prog dishwasher. When the prog cycle gets to 0.01 it carries on rinsing ad infinitum without drying. A quick wash is still going after 2 hours unless we switch machine off. Is this a prog fault that can be rectified?
Submitted: 3 years ago.
Category: Appliance
Expert:  Daniel replied 3 years ago.

Hi

 

When you get this fault its usually down to a heating fault so it takes ages to do a cycle and it sticks with 1 minute left on the display.

 

Yes this can be repaired as usually its either the heater itself or the control board. If you have a multi meter then you can test the heater.

You need to pull the appliance out and remove the right hand side panel.

From there look under the dishwasher in the middle you will see the heater.

Remove the wires and test the heater with your meter. But you need to fill it up with water so the plunger in the heater pushes out.

 

If the heater is faulty then you need to replace it but if the heater is fine then its more then likely a faulty control board.

 

Regards

Daniel and other Appliance Specialists are ready to help you

Related Appliance Questions