The side panel will have screws at the back
It will slide on clips at the bottom
One through the plastic cover at the top front
Another one behind the plastic front at the bottom
I have done all that but there are more screws attached to it behind the front panel
You normally have to take the whole of the front off to get the side off
At the bottom or top?
I realised that hence my question 'how do you remove the front panel'????
almost in the centre 2 screws I can see
Screws at the top and remove the plastic cover and display unit
I have tried that too
There will be additional ones at the bottom of the plastic top or clips depending on the model
there are no clips just screws the model is W2241
Have you undone the rubber door seal from the front also?
No not yet but I cannot get to the front panel screws even if I do that
You obviously do not know and I have wasted my money - will not be using this service again
Are you going to reply or is this it???
I am just looking at the instructions
Are you able to remove the screws from the inside of the machine?
cant you mail me the instructions or tell me where I can get some technical instructions then I can help myself?
No one cannot remove the screws without removing the front panel !!!!!
With the top off you should be able to get the display off and get your hand inside to get to the screws?
no - you obviously have no idea - so I have wasted my time and money - must go now