How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16558
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

how to change pump assembly on AEG OKO_Lavamat 74689 update PNC914

Resolved Question:

how to change pump assembly on AEG OKO_Lavamat 74689 update
PNC914 002 453 00
Submitted: 2 years ago.
Category: Appliance
Expert:  Daniel replied 2 years ago.
Hi

You need to remove the front panel to access the pump on this.

What you need to do is remove the top and then pull out the soap drawer and remove the screws on the panel.
Then look on the right hand side of the control panel and there may be a few screws there. Remove them.
Then remove the end caps on the control dial and remove the knobs from there.
Then you can remove the plastic control panel.
Then open the door and remove the outer seal clamp and unlip the door seal and then remove the door lock screws.
Then look on the very bottom of the front panel and remove the screw either side.
Then do the same on the top of the panel were the control panel has been removed and then you can remove the front panel.

Then you can access the drain pump from there and replace it.

If you need anymore info just get back to me.

Regards
Daniel and other Appliance Specialists are ready to help you