Boach dishwasher sgs45e62gb/64 stopped mid cycle and led display is totally blank as if machine has been unplugged from the socket. It has stopped during the final 20 minutes of the drain cycle on two occassions previously in the past 10 days, but on pressing the on/off button it starts up displaying the remaining time. On this occasion nothing happened when I pressed the on/off button.
Hi, welcome to Just answer
How old is this appliance ?
and have you already tried cleaning the drain pump assembly ?
Machine was purchased April 2006 and runs approx every 2 days. Drain area is regularly cleaned.
Even if the pump was blocked why would this prevent the display from showing anything?
OK, can you pull the appliance out and tip it backwards by around 45 degrees
let me know if any water comes off the base
if it does, then remove the base off the appliance and clean it completely
also check and make sure there are no leaks
after this is done problem should be solved...please let me know how it goes
No water comes out of base when tipped back. Went well past 45 degrees and nothing. Checked fuse continuity and socket outlet is live at same time. I am guessing that the control panel circuit board has failed, so maybe time for new machine?
OK, as it is completely dead it is time to replace the control board...a new one will cost around £110
If you have further questions I will be pleased to assist you – please use the REPLY link for further assistance..Please remember to RATE my answer Excellent or Good Service...Thanks
I guessed it might be the control board. Time to trawl the Internet for a replacement. Thanks for your time and assistance regarding the leak possibility. Regards,