How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16532
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

machine stopped with water still on board. machine has been

Resolved Question:

machine stopped with water still on board. machine has been emptied, water drained, filter cleaned. will not work - ERR on panel.
Submitted: 2 years ago.
Category: Appliance
Expert:  Daniel replied 2 years ago.

Can you post the model number please.
Regards
Customer: replied 2 years ago.

ZKI 245

Expert:  Daniel replied 2 years ago.

Try this and see what happens.
Turn the dial to off
Press and hold the start button and the button to the left of it.
Keep them both held in and turn the dial 1 click clockwise.
Keep the buttons held in till the leds flash then let go.
Now turn the dial 9 clicks clockwise and see if the error code comes up E??
Then turn the washer to off then on then back off again.
Then retry it and see how it goes from there and let me know what happens.
Regards
Customer: replied 2 years ago.

warning came up as E66. Moved to another position and machine has put water in. I am now spinning to empty water.

Expert:  Daniel replied 2 years ago.

Sorry this isn't good news.
E66 is a control board fault. Ive seen this error code quite a few times and its always the control board at fault here.
If you want to you can try this. Pull the washer out and remove the top and behind the panel is the main control board. Its the longer board. Push all the wiring blocks on there and make sure they are tight.
Then retry the washer and see what happens.
But to be honest with you nearly always the E66 is a control board fault on this which will need to be replaced to cure this.
If you need anymore info just get back to me.
Regards
Daniel and other Appliance Specialists are ready to help you