How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
19471162
Type Your Appliance Question Here...
George-Allsorts is online now

I have a bosch classixx 7 that is beeping and flashing

Resolved Question:

Hi, I have a bosch classixx 7 that is beeping and flashing lights. The cycle stops too.
Submitted: 2 years ago.
Category: Appliance
Expert:  George-Allsorts replied 2 years ago.
Hello, my name is George..

Please can you provide the Enr of the appliance from the label inside the door... Also let me know which lights are flashing.

Kindly be patient whilst awaiting any responses from me as I'm not constantly available.
Customer: replied 2 years ago.
Hi George,
The Enr no. is WTV74105GB/16 FD 9208 202333
Expert:  George-Allsorts replied 2 years ago.
Hi Robert, can you tell me which lights are flashing please
Customer: replied 2 years ago.
It's the 'drying' light and the 'Anti Crease/End' light
Expert:  George-Allsorts replied 2 years ago.
Hi, Thanks for that. I will check on that tomorrow when I am back in work
Expert:  George-Allsorts replied 2 years ago.
Hi Robert,

Click here to open the text file containing your fault

This will be valid until 6pm
George-Allsorts and other Appliance Specialists are ready to help you
Customer: replied 2 years ago.
Ok thanks, ***** ***** I fix this?
Expert:  George-Allsorts replied 2 years ago.

Take off the heater cover, check the wiring to the part and the part itself with a multimeter .. if there is a fault or break in the wiring to the part then repair that before doing anything else..

Check the part itself and if defective, replace it.

-----------------------------------------------------

It is now time for me to ask you to take the time to rate the assistance given to you today.. Once rated, I will assist you further if possible.

Customer: replied 2 years ago.
Hi again George, the Dropbox file is no longer viewable and I can't remember the name of the part, please may you send it again. Thanks.
Expert:  George-Allsorts replied 2 years ago.

Hi Robert,

I will do that for you, but the original assistance had not been rated, therefore, first I must ask you to rate the assistance given first.

Once you have rated, I will re-post the information, which will give you a part number and an image of the part..

Customer: replied 2 years ago.
Done.
Expert:  George-Allsorts replied 2 years ago.
Hi Robert,

Click here to open the text file containing your fault

This will be valid until 6pm