How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16557
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

I have a bosch logixx condenser dryer e.nr wtw84560gb/12 that

Resolved Question:

i have a bosch logixx condenser dryer e.nr wtw84560gb/12 that is only blowing out cold air, i think the reset button may need reseting but cannot locate it.
Submitted: 2 years ago.
Category: Appliance
Expert:  Daniel replied 2 years ago.
Hi This dryer is what they can a heat pump dryer. So theres no heater in there with a reset button on im afraid. It uses a compressor to create the heat it needs on these. How long have you had the dryer for?Has it only just stopped working?Does the drum still turn and is it running down the cycle? Regards
Customer: replied 2 years ago.

it is three years old but not used very much as its in our holiday home.

The drum and cycle is working ok just no heat!

Expert:  Daniel replied 2 years ago.
Hi Ok these dryer do take a long time to create any heat. As it needs to run for about 30 mins before you even start to feel any. So first remove the filters at the bottom and in the door and check there is no blockage in there as this can effect the heat in there as well. But if its not heating then its possibley the compressor. As this needs to run for it to get hot. So you need to remove the top and the right hand side panel and there you will see the compressor. Remove the cover on there to expose the wires and you need to test it with a multi meter and see if its faulty. Theres 3 pins on there. Test between all 3 and they should give a reading between them all. If they don't then the compressor is faulty. But if the compressor is fine then its possibley a faulty control board or temperature sensor you need to check. But im afraid to say there is not reset button on this dryer you can press. Regards
Daniel and other Appliance Specialists are ready to help you