How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Plumberpro Your Own Question
Plumberpro
Plumberpro, Home Appliance Technician
Category: Appliance
Satisfied Customers: 634
Experience:  Heating and hot water heating appliances experienced
77408428
Type Your Appliance Question Here...
Plumberpro is online now

I have a Danfoss tp5001+rf heating thermos stat. that

Customer Question

Hi,
I have a Danfoss tp5001+rf heating thermos stat. that has stopped communicating with the RX1 controller
Can you help?
Alan
***@******.***
Submitted: 2 years ago.
Category: Appliance
Expert:  Plumberpro replied 2 years ago.
Hi , it will need reconnecting
Plumberpro and other Appliance Specialists are ready to help you
Customer: replied 2 years ago.

Hi

How do I reconnect the 2 units.

Alan

Expert:  Plumberpro replied 2 years ago.
Step 1 TP5001-RF
Reset the unit by pressing the recessed
reset button.
Step 2 Press and hold V and + buttons for 3
seconds (TP5001-RF now transmits unique
signal continuously for 3 minutes).
Step 3 RX1
Press and hold buttons PROG and CH1 for
3 seconds until green light fl ashes once.
Step 4 RX2 (if applicable)
Stat 1 - perform steps 1-3 and 5.
Stat 2 - perform steps 1-2 and then press PROG and CH2 on RX2.
RX3 (if applicable)
Stat 1 - perform steps 1-3 and 5.
Stat 2 - perform steps 1-2 and then press PROG and CH2 on RX3 then
step 5.
Stat 3 - perform steps 1-2 and then press PROG and CH3 on RX3.
Step 5 TP5001-RF
Press V or Λ to select temperature - the unit will revert back to operating mode
Customer: replied 2 years ago.

Hi,

Working OK , the instructions I found on the internet did not say the reset button had to be pressed .perhaps that was thought to be obvious .

thank you for the assist.

Alan

Expert:  Plumberpro replied 2 years ago.
Your welcome