How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask KevinWhiteJA Your Own Question
KevinWhiteJA
KevinWhiteJA, Home Appliance Technician
Category: Appliance
Satisfied Customers: 995
Experience:  Worked on appliances for more than 15 years
70193065
Type Your Appliance Question Here...
KevinWhiteJA is online now

Whirlpool 2 draw dishwasher adg2900 Start button turns red

Resolved Question:

Whirlpool 2 draw dishwasher adg2900
Start button turns red and constantly on , motor running.
Can cancel but keeps going into above mode.
Submitted: 1 year ago.
Category: Appliance
Customer: replied 1 year ago.
Motor running sounds like it's draining
Expert:  KevinWhiteJA replied 1 year ago.
Hi, welcome to Just answer .... does it drain continuously or it stops and then drains ? the start button flashes or is it constantly on ?________________________________________________________________________________________If you have further questions I will be pleased to assist you .. Please remember to RATE my answer Excellent or Good Service when you are satisfied....Thanks
Customer: replied 1 year ago.
Constantly drains
Start should be green light. But is red not flashing. Continuous beeping. ..had to turn appliance off at wall .
Expert:  KevinWhiteJA replied 1 year ago.
ok , does it flash and beep in sequence or its will beep continuously ?
Customer: replied 1 year ago.
Beeping continuous no flash
Customer: replied 1 year ago.
Just put some water in drains no problem
Customer: replied 1 year ago.
(Posted by JustAnswer at customer's request) Hello. I would like to request the following Expert Service(s) from you: Live Phone Call. Let me know if you need more information, or send me the service offer(s) so we can proceed.
Customer: replied 1 year ago.
Had switch off at mains ...problem still persists
Customer: replied 1 year ago.
Any further advice ?
Expert:  KevinWhiteJA replied 1 year ago.
Sorry about late response... the problem is with the flow meter..to start, with the dishwasher unplugged pull it out and lay it on its back by around 45 degrees so that excess water drains off...after this take the left hand panel off and clean everything from there... plug it back and let me know how it goes.
Customer: replied 1 year ago.
Ok thanks ,will try this tomorrow...
Expert:  KevinWhiteJA replied 1 year ago.
OK please let me know how it goes
Customer: replied 1 year ago.
Hello Kevin
Got bottom draw working ...
Top draw. start button & lock button,flashing.no beeping.
Expert:  KevinWhiteJA replied 1 year ago.
Press and hold the start button for 20 seconds and see if this will reset the appliance.
________________________________________________________________________________________
If you have further questions I will be pleased to assist you .. Please remember to RATE my answer Excellent or Good Service when you are satisfied....Thanks
Customer: replied 1 year ago.
Tried that, no joy... Went into art mode but nothing happened. Stopped machine , back to lights flashing,also 3 lights on inside of draw.
Expert:  KevinWhiteJA replied 1 year ago.
OK, this indicates an issue with the main board which will need replacement, cost of repair will be around £120
KevinWhiteJA and other Appliance Specialists are ready to help you
Customer: replied 1 year ago.
Do you have a number for the main board. Thanks