How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
19471162
Type Your Appliance Question Here...
George-Allsorts is online now

My AEG favorit built in dishwasher is stuck on empty cycle.

Resolved Question:

My AEG favorit built in dishwasher is stuck on empty cycle. It bleeps 3 times every 7 seconds and the red light flashes by the ----> symbol on the control panel. HELP
Submitted: 1 year ago.
Category: Appliance
Customer: replied 1 year ago.
in other words the emptying pump is running all the time.
Expert:  George-Allsorts replied 1 year ago.

Morning Roger, my name is George,

Can you tell me the PNC / Product code of the appliance.. This will be on a lable that is normally down the right hand side of the door.

George-Allsorts and other Appliance Specialists are ready to help you
Customer: replied 1 year ago.
Customer: replied 1 year ago.
Hi George
Expert:  George-Allsorts replied 1 year ago.

Call answered by ansaphone

Expert:  George-Allsorts replied 1 year ago.

Attempting to call you again Roger

I have tried to call you a few times Roger but the answerphone keeps collecting the call

Expert:  George-Allsorts replied 1 year ago.

Nice to speak to you Roger.. Sorry you had a problem with the automated phone system.

If you follow the directions I gave you and there is still a leak following the expulsion of the water, then let me know and we can continue from that point...

If you forget the instructions I gave you, let me know and I will re-ring you.

If you need me to ring you again, let me know here, or text the number I phoned you from, and I will call you back to save your cost.

regards

George

Expert:  George-Allsorts replied 1 year ago.

Just to confirm your issue:

• i30 code: aqua control error detected
• The error is set if there is water detected in the bottom tray, or the drain
pump is disconnected or the winding in the pump is open circuit.
• Acoustic signal and visual alarm, depending on the appliance
customization; the program is restarted automatically in this alarm
condition.
• If this alarm condition occurs, the drain pump is activated.
• Time limit set: 10 sec