How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16384
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your Appliance Question Here...
Daniel is online now

Ive just installed an indesit ids105 dishwasher Assistant:

Resolved Question:

Hi Ive just installed an indesit ids105 dishwasher
Assistant: Just to clarify, what's the make and model of your dishwasher? And have you run a diagnostic test cycle?
Customer: Not sure how to run diagnostic
Assistant: Do you plan on doing the work yourself?
Customer: Yes
Assistant: Anything else we should know to help you best?
Customer: Its second hand, i have water at good pressure going in A while ago it had both wash and dry lights flashing
Submitted: 1 month ago.
Category: Appliance
Expert:  Daniel replied 1 month ago.

Hi

When you start the dishwasher going what actually happens?

Does it make any noises?

Are you getting any flashing lights from it? If so which lights are flashing?

Regards

Customer: replied 1 month ago.
It makes noise and then lights for wash and dry flash after 10 minutes or so
Customer: replied 1 month ago.
It's an f02 error
Customer: replied 1 month ago.
Any tips?
Expert:  Daniel replied 1 month ago.

F02 is a filling error code.

I assume you have checked the fill hose at the back isnt kinked up.

But if thats fine then when you start it going does any water enter at all?

If yes then its possibley the filling chamber at fault as theres a flow sensor in there which picks up the flow of water and if fails causes the error code.

In this case the plastic filling tank on the left hand of the dishwasher will need to be replaced.

But if no water enters at all then its possibley the water inlet valve. For this you need to access the water inlet valve at the back at the bottom were the fill hose goes to.

You need a test meter to check this. Test the coil were the wires go and it should read about 3.6K ohms. If faulty then the water inlet valve will need to be replaced to cure this.

So check them out if you can and see what you find from there.

Customer: replied 1 month ago.
Nice one thanks, ***** ***** take a look at those two options. Thanks
Expert:  Daniel replied 1 month ago.

No worries, Hopefully you can sort it from there.

Daniel and other Appliance Specialists are ready to help you