How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Matt Your Own Question

Matt
Matt, Mechanical Engineer
Category: Car
Satisfied Customers: 20789
Experience:  BEng hons Mech engineering, in auto industry 22 years
12772297
Type Your Car Question Here...
Matt is online now

my citroen berlingo 1.9 d 2005.will tick over for 2mins then

Resolved Question:

my citroen berlingo 1.9 d 2005.will tick over for 2mins then stop wont rev.
Submitted: 2 years ago.
Category: Car
Expert:  Matt replied 2 years ago.
Hello

I'd double check that the cam timing is right by doing a compression test across all cylinders as they should all be within 10-15 psi of each other

and then I'd check that the timing of the injection pump is still correct as if this is out then then you'll have no power

the tension of the timing belt also needs checking with 'C-tronic' tool or similar
Matt, Mechanical Engineer
Category: Car
Satisfied Customers: 20789
Experience: BEng hons Mech engineering, in auto industry 22 years
Matt and other Car Specialists are ready to help you
Customer: replied 2 years ago.

hi.thanks. cam timing is correct. the pump timing is correct.the compression is all good.this was all checked by r a c mechanic. he seems to think its fuel related since pipes were removed to replace belt. there is a bit of air showing in return pipe. on a test reader the van is showing no problems.is there a elec sender unit in the fuel tank on these.when opening injectors the fuel is flying out.

Expert:  Matt replied 2 years ago.
Hello Colin

unless the car is a HDi then it won't have an electric lift pump in the tank

the 1.9D just use the engine pump to suck the fuel through and you should also have a hand / primer pump in the engine bay on the filter housing

so if you haven't already it woudl be worth replacing the fuel filter and bleeding out the fuel system by pumping up the fuel using the hand pump in the engine bay on the filter housing, then crack off / loosen each injector pipe in turn while cranking the engine and getting an assistant to operate the primer. This will expel air from the injection side and the engine should fire up
Customer: replied 2 years ago.

yes pump and filter have been replaced.alli can do now is keep bleeding. no one knows what this is. it starts 1st time it will tick over for 2 mins then stop wont rev, start it again and again and does same.thanks any way.

Expert:  Matt replied 2 years ago.
Hello Colin

It may have developed an air leak on the fuel supply pipe from the tank to the engine. The engine has no separate lift pump and relies on the built in one in the injection pump. If a leak has developed on the fuel suction pipe then air entering the system will air lock the pump.
Try pumping up the fuel using the hand pump in the engine bay on the filter housing, then crack off / loosen each injector pipe in turn while cranking the engine and getting an assistant to operate the primer. This will expel air from the injection side and the engine should fire up. The problem will be cured by checking the supply pipe along its length for signs of leakage and repairing any you find.
If you daub each pipe joint with heavy grease and the issue goes away then wipe the grease away one at a time to highlight the problem joint

What Customers are Saying:

 
 
 
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
< Previous | Next >
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
  • Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible. Charles
  • As a single woman, I really appreciate an excellent and affordable opinion.
    Thank you Geordie, I will not hesitate to contact justanswer in the future!
    Sue
  • Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff. Jim
  • I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry. Stephanie P
  • Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help. Mary C.
  • This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!! Alex
 
 
 

Meet The Experts:

 
 
 
  • Greg

    Greg

    Technician

    Satisfied Customers:

    1067
    Automotive diagnostic tech
< Previous | Next >
  • http://ww2.justanswer.com/uploads/IN/indytech/2013-8-8_102717_SantoDomingo146598x6402.64x64.jpg Greg's Avatar

    Greg

    Technician

    Satisfied Customers:

    1067
    Automotive diagnostic tech
  • http://ww2.justanswer.com/uploads/35/350matt/2012-6-7_182356_matsavatr.64x64.jpg Matt's Avatar

    Matt

    Mechanical Engineer

    Satisfied Customers:

    4197
    BEng hons Mech engineering, in auto industry 22 years
  • http://ww2.justanswer.com/uploads/TE/techmachine/0601821347169_717372168_8940977_39623330_o.64x64.jpg Ross's Avatar

    Ross

    Diagnostic and repair technician

    Satisfied Customers:

    452
    Licensed diagnostic and repair technician
  • http://ww2.justanswer.com/uploads/RO/RobMechanic/068.64x64.JPG Rob's Avatar

    Rob

    ASE Certified Technician

    Satisfied Customers:

    82
    30 years trade experience
  • http://ww2.justanswer.com/uploads/UK/ukiaibal/2012-11-9_205920_SAM0109.64x64.JPG uk_iaibal's Avatar

    uk_iaibal

    UK Car Mechanic

    Satisfied Customers:

    1
    Verified Car Mechanic.
  • http://ww2.justanswer.com/uploads/NA/nabilc/nabilc_avatar.64x64.jpg Billy's Avatar

    Billy

    Trainer/ Master Technician

    Satisfied Customers:

    38
    Trainer 8+ years, master tech. 10+ years, SAE member
  • http://ww2.justanswer.com/uploads/MI/mikeamechanic/2013-4-2_175558_photo.64x64.JPG Mike Kelly's Avatar

    Mike Kelly

    Auto Service Technician

    Satisfied Customers:

    1256
    17 years experience as an auto mechanic, foreign and domestic. 5 years running my own repair business.