How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Robert Your Own Question

Robert
Robert, UK Qualified Car Technician
Category: Car
Satisfied Customers: 4368
Experience:  Fully qualified / self employed garage technician in the UK
13210289
Type Your Car Question Here...
Robert is online now

Illuminated electronics fault indicator appears no spark corsa

Customer Question

Illuminated electronics fault indicator appears no spark corsa poss causes/cure
Submitted: 1 year ago.
Category: Car
Expert:  Robert replied 1 year ago.

Hi..there..

If there is no spark then it possible you have lost signal from either crank/cam sensor/ id say check the crank sensor first as normally thats where the ecu take readings from,as per crank position to provide spark/coils.you dont mention year/nor engine size etc..have you double checked the timing belt just to be sure...however if your fault warning light is on..then id suggest before making any replacement with those sensors is to see what fault codes you have stored in the ecu,plug the car in to get those codes.any good mechanic would do that first.hence why the warning is on..so thats one possible cause/step forward from here..I do hope this helps

Customer: replied 1 year ago.

Vauxhall Corsa-C 1.2L. Where is this sensor located ?

Expert:  Robert replied 1 year ago.

Hi..there..

They actually locate these in differing areas to be honest..but the best place to check on the 1.2 is on the lower edge of the engine block / back of the engine..near the drivers side inner cv joint as it enters the box..look on the engine block and you should see the sensor/3pin multi plug..and the sensor held to the block with a single torx bolt...as the impulse ring the sensor reads is inside the engine on the crank..if you don't see it there..then inspect the crank pulley as you look in from the drivers side wheel wheel and see if the sensor is on the left hand side of the crank pulley..you'll know the sensors on that side if the crank pulley has the target/impulse ring on that...

What Customers are Saying:

 
 
 
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
< Previous | Next >
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
  • Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible. Charles
  • As a single woman, I really appreciate an excellent and affordable opinion.
    Thank you Geordie, I will not hesitate to contact justanswer in the future!
    Sue
  • Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff. Jim
  • I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry. Stephanie P
  • Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help. Mary C.
  • This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!! Alex
 
 
 

Meet The Experts:

 
 
 
  • Greg

    Greg

    Technician

    Satisfied Customers:

    1067
    Automotive diagnostic tech
< Last | Next >
  • http://ww2.justanswer.com/uploads/IN/indytech/2013-8-8_102717_SantoDomingo146598x6402.64x64.jpg Greg's Avatar

    Greg

    Technician

    Satisfied Customers:

    1067
    Automotive diagnostic tech
  • http://ww2.justanswer.com/uploads/35/350matt/2012-6-7_182356_matsavatr.64x64.jpg Matt's Avatar

    Matt

    Mechanical Engineer

    Satisfied Customers:

    4197
    BEng hons Mech engineering, in auto industry 22 years
  • http://ww2.justanswer.com/uploads/TE/techmachine/0601821347169_717372168_8940977_39623330_o.64x64.jpg Ross's Avatar

    Ross

    Diagnostic and repair technician

    Satisfied Customers:

    452
    Licensed diagnostic and repair technician
  • http://ww2.justanswer.com/uploads/RO/RobMechanic/068.64x64.JPG Rob's Avatar

    Rob

    ASE Certified Technician

    Satisfied Customers:

    82
    30 years trade experience
  • http://ww2.justanswer.com/uploads/UK/ukiaibal/2012-11-9_205920_SAM0109.64x64.JPG uk_iaibal's Avatar

    uk_iaibal

    UK Car Mechanic

    Satisfied Customers:

    1
    Verified Car Mechanic.
  • http://ww2.justanswer.com/uploads/NA/nabilc/nabilc_avatar.64x64.jpg Billy's Avatar

    Billy

    Trainer/ Master Technician

    Satisfied Customers:

    38
    Trainer 8+ years, master tech. 10+ years, SAE member
  • http://ww2.justanswer.com/uploads/MI/mikeamechanic/2013-4-2_175558_photo.64x64.JPG Mike Kelly's Avatar

    Mike Kelly

    Auto Service Technician

    Satisfied Customers:

    1256
    17 years experience as an auto mechanic, foreign and domestic. 5 years running my own repair business.