How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Matt Your Own Question
Matt
Matt, Mechanical Engineer
Category: Car
Satisfied Customers: 21876
Experience:  BEng hons Mech engineering, in auto industry 22 years
12772297
Type Your Car Question Here...
Matt is online now

1.8 laguna registration. Heater.tempature won't give OUT HOT

Resolved Question:

1.8 laguna registration. Heater.tempature won't give OUT HOT AIR. FLUSHED RADIO, REPLACED THERMOSTAT, ONLY RUNS WARM, NO LOSS OF WATER, 70K, VERY SMOOTH AND POWERFUL DRIVE
Submitted: 1 year ago.
Category: Car
Expert:  Matt replied 1 year ago.
HelloVery first thing to do is ensure the coolant level is up to the mark and if low top it up with the correct antifreeze or pre-mixed coolant as stated in the owners manualI'd then check that the engine is getting up to temperature, if its not then its likely the thermostat needs changing.If this is OK have a feel of the two coolant pipes that pass into the car through the engine bay bulkhead, both should be warm with a warm engine. If they're not then its likely the heater matrix is blocked and you should do a reverse flush on the cooling system to try and clean it out. This is done by removing the top hose from the radiator and placing a garden hose into the engine water outlet, and then run the hose until you get clean water coming out of the radiator.If this doesn't help this only leaves checking out the motor / cable that moves the air mixing flap that allows the hot air from the matrix to enter the car air system. This flap is controlled by the temperature knob / dial etc and I think is controlled with a small motor for your car so the thing to do is first get access to the back of the control knob and measure the voltages is present there, then trace the wiring back into the dash from the control to locate the motor. It’s worth first checking the fuses for the fan / control circuit I'd recommend first removing the glovebox ( undo lower edge hinges from dash) to gain access to the dashboard inner and also allow you to shine a torch to the back of the central console so you can start tracing the wire back and see how things are put together
Matt and other Car Specialists are ready to help you