Honda Repair Questions? Ask a Mechanic for Answers ASAP
Hellothe first thing to do is bleed the clutch hydraulics and ensure that you replenish the all fluid in the system and get any trapped air outI favour having a clear hose from the nipple to a jar 1/2 full of old fluid and with the nipple closed your assistant pushes the pedal up and down a few times, then holds it down whilst you then crack open the nipple and close it again whilst fluid is still flowing.If this doesn't help then next check the gear linkage for any worn bushes or pivots as any lost motion means reduced effort at the gearbox and replace as necessary. Ideally have your assistant move the gear lever with you watching the linkage and see if you can spot where there is any excessive play or lost motion.
If its a cable type linkage check along the cable lengths for any damage or signs of heavy wear / fretting, if you find any replace the cable. There may be some adjustment on the cable tension at the gearbox end (depending on the year) and the cable should be tensioned so there is a minimum of slack but not so its taughtThen check gearbox oil levels and if its not been changed in the last 20K miles then drain it off and fill with fresh. I can strongly recommend the use of Castrol Syntrans 75W90 (was called SMX-S) as I've known it help with shift issues on many manual gearboxes
If you still have issues with the hydraulics and its good after bleeding but then gets worse after a few days / hours, then I'd try leaving the clutch pedal held down overnight by bracing the pedal against the seat base with a piece of wood or similar, this is to try and force the seals inside the slave to take a set in the right orientation as over time they can shrink and draw air back in when you take your foot off the pedal.
This shrinkage isn't enough to leak any fluid but the gap is big enough to draw air in (gas being harder to seal than fluid) if this doesn't work I'm sorry to say that the slave cylinder is going to need changing.
also if the fluid is dark in colour this is a sign the seals are breaking up
its possible, if the slave cylinder inside the gearbox was abused during fitting then it may be leaking fluid or binding up
Try bleeding it 1st and see what state the fluid is in that leaves the system
do you still need help?
Bear in mind that the site takes a deposit from you at the beginning and this is held by the site until you rate my answer at which point the cash is split between the site and the expert. I am only paid for my work on this question if you rate my answer, using the star system at the top of the screen. Please do not forget! Thank you