2001 3.2 cuts out while driving starts and idles roughly for a minute and failsafe light comes on also cruise control n/w
This could be an airleak after the airflow meter, any air dragged in here isn't 'seen' by the ECU and so not compensated for and can lean the engine out and can also allow the engine to rev up when not desired causing rough running.
As its a mechanical fault it tends not to turn on the fault light and you can sometimes hear a 'hissing' noise with the engine running.
Check the hose clips for tightness and inspect the trunking for any cracks or splits and also all the vacuum system, the small bore pipes and fittings for cracks and missing parts.
The best way to locate a leak is to have the engine running and warm and then spray lighter gas /propane around each joint in turn. If the engine rev's up you've found your leak.
Now you might think that spraying lighter gas around a hot engine isn’t wise, however the flash /ignition point of gas is about 400°C so you need a naked flame or spark to set it off and I’ve used this method for many years without incident.
Work your way through each possible joint one at a time and you should find it. I use a slightly flattened piece of brake pipe and some rubber hose from the can of lighter gas to provide a spraying 'wand' and allow a direct blast of gas into each area, especially those difficult to reach with large implements.
It’s also worth getting the fuel pressure checked as if this is low due to a blocked filter or faulty regulator or even a poorly pump will all result in insufficient fuel being delivered to the engine
Might also be worth checking the wiring and connector to the airflow meter for any signs of corrosion or damage. you can do a quick fault find if you unplug the meter and run the engine without it.
if the engine condition is the same then chances are the meter or the connection to it is faulty
Air leaks are very temperature dependent as gaps can open or close up as things expand with heat, so the weather and engine temperature can effect them.
This leads them to be quite intermittent in the case of mild leaks
its also worth cleaning the airflow meter by removing it from the car and spraying the exposed sensor wires inside the tube with a brake or switch cleaner - ensure that the cleaner is one of the old fashioned, non Eco type that does not leave a residue
On no account touch the sensor wires with anything physical as they are extremely fragile
I could try running the car but it turns over and wont start as if ran out of fuel but it hasent
Its possible that the ECU isn't opening the fuel injectors, if the injectors are working you can hear them click - its difficult to hear them with background noise so use a long screwdriver like a stethoscope, placing the handle end in your ear and the metal tip against the body of the injector whilst your assistant turns the engine over.
If you can't hear anything check the ECU power is present by measuring voltage at the fusebox and on its relay socket if OK then check the connections to the crank speed sensor and consider replacing this sensor if the wiring / connections look OK
If the car will start using a squirt of quick/ easi start into the intake then this confirms the problem is lack of fuel
Also its worth checking that the electric pump that feeds the injectors is working correctly, it should run for a few seconds then switch off when you first turn the ignition on. If you remove the filler cap to the fuel tank and listen inside while your assistant flicks the ignition you should hear it clearly
If the connections to this are corroded or damaged then the pump could stop at any time. Check that its relay switches in and out and the relay contacts are clean and bright – replace the relay if in any doubt and do the same for the fuse, ideally measure the voltage at the pump and check its getting 12V.
You should be getting around 3 bar measured at the injector rail check to see if the plugs are getting wet indicating fuel is flowing – if not and the injectors are opening then there’s a problem with the pump or the filter or even the pressure regulator