How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Matt Your Own Question

Matt
Matt, Mechanical Engineer
Category: Nissan
Satisfied Customers: 20615
Experience:  BEng hons Mech engineering, in auto industry 22 years
12772297
Type Your Nissan Question Here...
Matt is online now

I get a roaring sound after about 5 miles in my Nissan Qashqai

Customer Question

Hi I get a roaring sound after about 5 miles in my Nissan Qashqai that gradually gets louder it sounds like a jet plane. What could be causing this.
Submitted: 1 year ago.
Category: Nissan
Expert:  Matt replied 1 year ago.
Hello This could be an airleak after the airflow meter, any air dragged in here isn't 'seen' by the ECU and so not compensated for and can lean the engine out and can also allow the engine to rev up when not desired causing rough running.As its a mechanical fault it tends not to turn on the fault light and you can sometimes hear a 'hissing' or roaring noise with the engine running. Check the hose clips for tightness and inspect the trunking for any cracks or splits and also all the vacuum system, the small bore pipes and fittings for cracks and missing parts. The best way to locate a leak is to have the engine running and warm and then spray lighter gas /propane around each joint in turn. If the engine rev's up you've found your leak.Now you might think that spraying lighter gas around a hot engine isn’t wise, however the flash /ignition point of gas is about 400°C so you need a naked flame or spark to set it off and I’ve used this method for many years without incident.Work your way through each possible joint one at a time and you should find it. I use a slightly flattened piece of brake pipe and some rubber hose from the can of lighter gas to provide a spraying 'wand' and allow a direct blast of gas into each area, especially those difficult to reach with large implements.
Expert:  Matt replied 1 year ago.
Hi
do you still need help?
Bear in mind that the site takes a deposit from you at the beginning and this is held by the site until you rate my answer at which point the cash is split between the site and the expert. so if my answers have been helpful please rate my answer.

What Customers are Saying:

 
 
 
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
< Previous | Next >
  • 9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much. Phil
  • Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible. Charles
  • As a single woman, I really appreciate an excellent and affordable opinion.
    Thank you Geordie, I will not hesitate to contact justanswer in the future!
    Sue
  • Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff. Jim
  • I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry. Stephanie P
  • Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help. Mary C.
  • This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!! Alex
 
 
 

Meet The Experts:

 
 
 
  • Jake

    Jake

    Nissan Technician

    Satisfied Customers:

    217
    Experienced collision repair technician, Pulaski Tech graduate and DSM hobbyist.
< Last | Next >
  • http://ww2.justanswer.com/uploads/05/05muranosl/2012-1-26_195212_JA.64x64.JPG Jake's Avatar

    Jake

    Nissan Technician

    Satisfied Customers:

    217
    Experienced collision repair technician, Pulaski Tech graduate and DSM hobbyist.
  • http://ww2.justanswer.com/uploads/FO/fordtwo/2014-12-19_163422_arrepair.64x64.jpg Robert's Avatar

    Robert

    UK Qualified Car Technician

    Satisfied Customers:

    79
    self employed in the motor repair buisness 19years
  • http://ww2.justanswer.com/uploads/IN/indytech/2013-8-8_102717_SantoDomingo146598x6402.64x64.jpg indy-tech's Avatar

    indy-tech

    Import tech

    Satisfied Customers:

    76
    Import technician
  • http://ww2.justanswer.com/uploads/35/350matt/2012-6-7_182356_matsavatr.64x64.jpg Matt's Avatar

    Matt

    Mechanical Engineer

    Satisfied Customers:

    4443
    BEng hons Mech engineering, in auto industry 22 years
  • http://ww2.justanswer.com/uploads/TE/techmachine/0601821347169_717372168_8940977_39623330_o.64x64.jpg Ross's Avatar

    Ross

    Diagnostic and repair technician

    Satisfied Customers:

    453
    Licensed diagnostic and repair technician
  • http://ww2.justanswer.com/uploads/RO/RobMechanic/068.64x64.JPG Rob's Avatar

    Rob

    ASE Certified Technician

    Satisfied Customers:

    82
    30 years trade experience