Hello, I’m Nathan, and I’ll be assisting you today.
Sorry to hear that you’re having trouble with this but I’ll do my best to help you out.
This is a “diffuse” message which simply denotes an internal fault. That can be caused by anything from debris/obstruction (paper jam, bent/damaged rails, out of place purge assembly/wiper, or dirty/dislocated encoder strip) to an actual hardware defect (bad sensor or control board, faulty carriage drive motor/gear/belt, bad printhead/carriage pcb).
What we can try here are some cleaning and reset steps.
First, open up the printer, and check for any internal debris such as scraps of paper, paperclip or staple, etc. Then remove the input paper supply.
Check if you’re able to move the carriage manually, or if it moves on its own when lifting the lid. If it does move, you can proceed with cleaning by blowing out the Inside compartment with compressed air and checking carefully on both sides for any obstructions. Next remove all of the ink cartridges, then clean the metal electrical contacts on the back, as well as where they mate up inside the printer, using qtips and rubbing alcohol. Dry well, then reseat the cartridges. Then wipe down the encoder strip, which is a clear plastic strip running the width of the printer, that sits just slightly above and behind the carriage. Next take a piece of heavy paper like card stock and push that through the rollers (feed path) to dislodge any last bits of paper that may be stuck.
Slide the paper guides to the center then back out, fan the front edge of the paper stack, and replace the paper supply.
Then reset the machine:
unplug power at the wall outlet
wait 5 minutes
press and hold the power/on button for 60+ seconds
keep holding while plugging back in, and for another 60 seconds after, then release
Let me know the results, and I’ll advise further if needed.