How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Techdesk Your Own Question
Techdesk, Service Engineer
Category: Appliance
Satisfied Customers: 16409
Experience:  Whitegoods engineer working for a multibranded national company in the UK
Type Your Appliance Question Here...
Techdesk is online now

I have a Creda S130e and yesterday I used the cook time function.

This answer was rated:

I have a Creda S130e and yesterday I used the cook time function. The cook time ended and I used the oven on minute minder. The oven then tripped the fuse box. When I went to use it today the fan and light work in the main oven but it does not get warm
When you try using it, does the temperature light on the front come on?

Customer: replied 4 years ago.
Thanks for that.

I'm advising on the most common cause of the problem you have.

Isolate the power to the appliance. Disconnect it from the electrical supply

As the temperature light is on, the most likely cause of the problem is a failure of the circular element in the oven.

The method of changing will depend on the element fitted at the time of manufacture.

There are 2 types, one is held from the front by screws, the other is held from the rear by nuts. (Your one is normally from the front)

If the interior light is on the rear panel, take the light glass off first.

Take the rear panel inside the oven out.

This will reveal the element and the fan.

Take the screws holding the element in place out.

Bring the element and the wiring into the oven cavity.

(Be careful not to pull the wires off as you bring the element into the cavity, if you do, you'll need to take the oven out, rear panel off to be able to retrieve the wires. Don't try the machine if you have lost a wire, retrieve it first).

If the element is not obviously blown, you need to test it with a multimeter to see if it's open circuit.

Swap the wiring on to the new element. (Don't lose the wires into the back or you'll need to take the appliance out and remove the panels to retrieve them).

Fit the element in place and replace the cover.

Turn the power back on and set the clock.

Try the oven again.

If there are no screws holding the element in place, take the cooker out and take the rear cover off.

You can now access the wiring and the nuts holding the element in place.

If the element tests ok, let me know.

Obviously, if you cannot do this work yourself, you'll need to call someone in to do it for you.

Hope this helps
Let me know how it goes or if you need more help
Techdesk and other Appliance Specialists are ready to help you