How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Techdesk Your Own Question
Techdesk, Service Engineer
Category: Appliance
Satisfied Customers: 16409
Experience:  Whitegoods engineer working for a multibranded national company in the UK
Type Your Appliance Question Here...
Techdesk is online now

hoover tv630 001 dryer. Just need wiring diagram for the

This answer was rated:

hoover tv630 001 dryer.

Just need wiring diagram for the panel buttons.
You can't get just a wiring diagram for the buttons, the wiring diagram is a schematic of the whole machine.

If you're looking for pictures showing the wires to the buttons, sorry, that doesn't exist.

I can provide the circuit diagram and wiring diagram but I need you to be sure this is actually what you want.

Customer: replied 3 years ago.



I have just have 4 wires I need to connect, Red, White, and 2 green wires to the correct buttons.


I am sure it will be on the diagram, please send.





Thanks for that.

I've uploaded the diagrams for you.
Copy and paste the following into a new browser window, it will link you to the download.

A quick look at the diagrams show the start switch has the green wires to it and the half heat switch has the red and white wires.

Hope this helps
Customer: replied 3 years ago.

Hi again,


Just back from lunch connected as stated, but the machine is showing an earthing problem, checked with a multi meter and there is a continuity from the red wire to earth, any suggestions?



Sorry, is this with the wire disconnected?

What work did you do on the machine that required the wiring taking off?

Customer: replied 3 years ago.

Hi again,


Resolved the shorting problem, it was in the heater element case, the casing had collapsed and was touching a bottom element.


Turned machine on and was working.


The reason for taking it apart was the ceramic bearing at the drum's rear had disintegrated. I machined a new roller bearing housing setup and bolted it in.


Now thanks for your prompt help.



Thanks for letting me know.

Good luck with the appliance.

Techdesk and other Appliance Specialists are ready to help you