How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
Type Your Appliance Question Here...
George-Allsorts is online now

SMEG DISHWASHER MODEL DWI 710 E1 not going through full cycle

Customer Question

SMEG DISHWASHER MODEL DWI 710 E1 not going through full cycle just keeps running
Submitted: 3 years ago.
Category: Appliance
Expert:  Michael replied 3 years ago.
I am sorry to hear that,
E1 indicates a flooded base at the bottom.
What you need to do is pull machine out and tip it backwards to drain the water out from the bottom.
If its built in then you need to remove the inspection panel at the bottom and then use a sponge to sponge the water out.
When the base is clear then the anti flood will reset itself and should be back to normal then.
If you need anymore info just get back to me.
Please don’t forget to rate my service before closing this page,
then you can always contact me the very same way at no additional cost if you have further questions about this;-)
Thank you and have a wonderful day!
Tech Michael
Expert:  George-Allsorts replied 3 years ago.
Hello, my name is ***** ***** The dishwasher is proberbly suffering from a defective heating element... The Smeg DWI710E1 uses a combination heating element and the part number is *****

Before you change the heater It may be best to check it out... Remove the RH side panel and the heater is under the tank.. See the picture below for identification. Use a multimeter to test continuity between the two connection within the socket on the heater.