How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
Type Your Appliance Question Here...
George-Allsorts is online now

How to get to the oven roller door catch on a c60etc

This answer was rated:

how to get to the oven roller door catch on a c60etc
Hello, my name is George..

1. Remove the top door to access the 2 fixing screws for the main door top hinge.
2. Remove the hinge and lift the door off the bottom hinge.
3. Using suitable protection, lay the door down and slide out the inner glass.
4. Remove the plastic grommets from the door extrusion to access the handle retaining screws.
5. The door striker is fixed to the door extrusion by 2 screws.
6. On reassembly do not over tighten the screws retaining the door handle to the outer glass panel.

Kindly be patient whilst awaiting any responses from me as I'm not constantly available.
Customer: replied 2 years ago.

I want to get to the roller catch not the striker

Is the roller on the door or on the body on this model?
Customer: replied 2 years ago.

On the body

Remove Control Panel
Remove the control knobs and timer buttons.
Remove 2 screws from the underside of the control panel.
Slide the control panel assembly to the left and disengage from the upper retaining bracketsSide Panels

Remove Ceramic Hob
Remove the 2 screws at the rear of the hob, the 2 lowest of the 6 screws.
Remove the 2 screws from the front underside of the hob.
Lift the hob and unplug the multi connection block.
Put hob to one side.

Remove Top Oven Door Assembly
With the door open, slide over the saddle bracket from the locked vertical position to the unlocked
horizontal position.
Shut the door, but not completely.
Grip the door on the two external sides and pull it towards you, pulling it out of its seat.
Lay the door on a suitably protected flat surface to one side.

Remove 5 screws on the outer rear panel
Remove the 7 screws from the front of the side panel and 4 from the rear.
George-Allsorts and other Appliance Specialists are ready to help you