How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 17410
Experience:  20+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
Type Your Appliance Question Here...
Daniel is online now

Red arrow flashing and bleeping noise

This answer was rated:

red arrow flashing and bleeping noise

Can you post the make and model number of the appliance please.

Customer: replied 2 years ago.

“f34502v10” dishwasher AEG

Thats great.

If you look at the flashing light you need to count the number of flashes from it inbetween the pause and let me know.

Customer: replied 2 years ago.


Ok that error code is a water leak in the base which has activated the flood switch in there. What you need to do to reset this pull the dishwasher out from under the unit and lean it 45 degs backwards and this will allow the water to drain out from the base.Once the water is out the flood switch will reset itself and stop the end of cycle light flashing. Or if you cannot pull it out you need to remove the outer door panel and then remove the wooden kick board at the bottom of the kicthen and remove the metal panel below the door.From there you can use a sponge and soak the water out from the base and this will reset the flood switch. Once thats clear retry it and see how it goes. Fingers crossed this will be a one off overflow and it will be fine from there. But if it happens again then theres a leak in there which you need to find and fix to cure this here. If you need anymore info just get back to me. Regards
Daniel and other Appliance Specialists are ready to help you