How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
Type Your Appliance Question Here...
George-Allsorts is online now

Good afternoon I have a Belling double oven electric hob.

Customer Question

Good afternoon I have a Belling double oven electric hob. My helpful neigbour cleaned my oven. He removed the silver facia to replace the rubber seal. To do that he removed the Black, white, orange and red wires from the rear of the timer display. He forgot to write down their positions and now dose not know which terminals are which. Can you help please Thanks

Submitted: 2 years ago.
Category: Appliance
Expert:  George-Allsorts replied 2 years ago.
Hello, my name is George..

Can you supply me with the model number please.. This is on a label at the bottom edge of the oven.

Kindly be patient whilst awaiting any responses from me as I'm not constantly available.
Customer: replied 2 years ago.

Model number###-##-####/p>

I need to re-connect the programmer and am not sure as to where each of the different coloured cables go.



Expert:  George-Allsorts replied 2 years ago.
Are you near to the cooker John, as I'm going to need you to tell me where the wires go to...

I have the wiring diagram here and i'm waiting.

Customer: replied 2 years ago.

Hi George I am away from my home at the min so I can not look at the cooker. My pal removed the stainless steel fascia to repair a thin black seal. He disconnected the leads that connect the timer/programmer and display to the oven. I want to make sure that I put the wires to the correct spade terminals. If the service manual shows this information could you email the docs as suggested. Should I struggle I will contact you again??



Expert:  George-Allsorts replied 2 years ago.
Hi John, the wiring in the wiring diagram sre different colours so would need to be traced (this is common).

The only way I can send you the wiring diagram and schematic diagram is if you accept an Additional Service Request... one has been sent to you by email.