How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts, Senior Appliance Technicial Manager
Category: Appliance
Satisfied Customers: 1448
Experience:  A whitegoods technician with 30+ years service in Domestic Appliance Service & Repair, and General Mechanical & Electrical Repair
Type Your Appliance Question Here...
George-Allsorts is online now

Bosch washer. no motor action.

This answer was rated:

bosch washer. no motor action.

Hi David, it's George

Can you heaar clicking from the control panel at all when the motor should be operating?

Customer: replied 1 year ago.

yes i can hear a click on off and the pump is running constant

Before doing anything else, check the base of the washer for water.. Tilt the washer backwards to expel any water from the base..

Let me know what result you get so that we can then continue.

Customer: replied 1 year ago.

hi there. there is no water but this is a wahing machine is that ok

Yes, I know it is a washing machine David.

Can you tell me what program it is in?

Customer: replied 1 year ago.

i have selected just a normal spin cycle. it pumps out and the motor never turns.

Does the pump run for the full cycle?

Customer: replied 1 year ago.

the spin cycle starts at 12 mins and pumps out perfect, but the motor never turns. the machine seems to complete the cycle and sounds an alarm to let you know it is complete.

Then since the relays on the board are clicking as would be expected, I suggest that the problem lies within the motor itself..

Check the toc of the motor.. You'll find it in the field coils

Customer: replied 1 year ago.

will do but i will need to get back to you. thanks.

Ok David.. Chat soon

Customer: replied 1 year ago.

hi there. i have checked the motor and it is ok. i used a volt detector and there is no power getting to the motor. i took the module off and found a few damaged tracks at the connector terminal. i hammered flat some fuse wire and folded it over the edge and soldered them. seems to be ok now. good OLD bosch machines. can still fix them with a hammer.

Excellent.. The motor not getting power.. Same as TOC issue. Probem is, what caused it?

Please take the time to rate my assistance using the stars provided, as it is the only way I get credited for responding to you.

George-Allsorts and other Appliance Specialists are ready to help you
Customer: replied 1 year ago.

the carbons had worn right down and may have overheated the tracks.