How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • Go back-and-forth until satisfied
    Rate the answer you receive.
Ask canuck the pro Your Own Question
canuck the pro
canuck the pro, Plumber
Category: Appliance
Satisfied Customers: 8221
Experience:  Plumber
Type Your Appliance Question Here...
canuck the pro is online now

My brothe kh900 knitting machine the on off light keeps

Customer Question

My brothe kh900 knitting machine the on off light keeps flashing
JA: How long have you had your KH900?
Customer: Not long I bought it on eBay I haven't used it for a week
JA: What have you tried so far?
Customer: Unplugging it and putting it back on but same thing
JA: Anything else you want the Electronics Expert to know before I connect you?
Customer: No that's all thanks
Submitted: 11 days ago.
Category: Appliance
Expert:  Virtual-mod replied 10 days ago.

I've been working hard to find a Professional to assist you with your question, but sometimes finding the right Professional can take a little longer than expected.

I wonder whether you're ok with continuing to wait for an answer. If you are, please let me know and I will continue my search. If not, feel free to let me know and I will cancel this question for you.

Thank you!
Expert:  canuck the pro replied 10 days ago.

Hi, my name is ***** ***** I have been in the home improvement and repair field for 20 years. I will be very glad to help you today.

Expert:  canuck the pro replied 10 days ago.

You will remove your needle -plate, bobbin and bobbin case and clean that area out completely of any excess thread, lint or debris. You can do this with your brush that was provided, or simply use a tweezer. Once that is done, place a drop of sewing machine oil in the center of your shuttle ( metal piece holding bobbin and bobbin case ) Re assemble your bobbin area. Now, moving to the top. Un thread your machine and raise your presser foot so that your tension discs are open. Take a scrap piece of material and run it through your top tension back and forth in the pathway of the threading. This will remove any lint, debris or extra thread you have in there that is not allowing your top tension to close properly. Now rethread the machine making sure you are through your guides, take up lever and topp tension correctly. Before you are going through your needle keep gently pulling your thread while lowering your foot. You should feel the top tension beginning to grab your thread. If not, you are either in front of or behind your tension discs, so rethread it again. If that does not work then there may be thread around the take up area. Remove the face plate (cover on upper left end of the machine) Inside there you will see the connecting mechanism for the thread take-up. There will probably be thread wrapped around that, which will need to be cleaned out and the mechanism and lubricated.