How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • Go back-and-forth until satisfied
    Rate the answer you receive.
Ask Erdal Zal Your Own Question
Erdal Zal
Erdal Zal,
Category: Appliance
Satisfied Customers: 4460
106347225
Type Your Appliance Question Here...
Erdal Zal is online now

The microwave function on my Sharp combi oven has stopped

This answer was rated:

The microwave function on my Sharp combi oven has stopped working. Can it be repaired?
JA: Is your Sharp oven gas or electric? How old is it?
Customer: it is electric - I think it’s six years old
JA: How long has this been going on with your Sharp oven? What have you tried so far?
Customer: Just discovered it now. Tried to microwave porridge and no heat at all
JA: Anything else we should know to help you best?
Customer: Looks like the cooker is working fine - haven’t tested the grill or other functions
Customer: replied 12 days ago.
The microwave function has just packed up. Can it be repaired economically?
Customer: replied 12 days ago.
Error code E02 just appeared
Customer: replied 12 days ago.
I am not hearing anything from you!

Good Morning

Welcome to JustAnswer and thank you for your question. My name is***** am an expert from Germany and have been working as an equipment technician for 19 years. I work with a language translation program and I would be very grateful for your understanding.
I'm sorry I can't make a call, but another expert can do it for you if you want. I will try to help you as best I can via chat.
I am sorry that you faced this problem!

The error message EE2 means that the lower magnetron MG2 is no longer working.

This can have the following causes:

- Defect of the MG2 magnetron below
- Defect of the HV transformer T1 (rear)
- Defect of the HV rectifier unit
- Break in the HV wiring harness
- Defective HV capacitor C2
- Defective door bolt switch SW2
- Defective fuse F2
- Defective magnetron thermal fuse TF2
- Defective high voltage fuse F4
- Defective high voltage fuse F5
- Defective magnetron thermistor (above) TH1
- Defective magnetron thermistor (below) TH2
- Defective relay RY-4

These components must all be checked by a service technician by measuring and replaced in the event of a defect. But you can do this first to perform a reset. Switch off the power supply via the circuit breaker or wall for at least 15 minutes. Then switch on the power supply for 1 minute. And then immediately switch off the power supply again. Then switch it on and try it out.

Please feel free to continue this topic if you have any further questions. I would be very happy to help you!
Kind regards,
Erdal

Erdal Zal and other Appliance Specialists are ready to help you