How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mike Kelly Your Own Question
Mike Kelly
Mike Kelly, Ford Mechanic
Category: Ford
Satisfied Customers: 141
Experience:  17 years experience as an auto mechanic, foreign and domestic. 5 years running my own repair business.
Type Your Ford Question Here...
Mike Kelly is online now

fiesta 2009 wont start

Customer Question

hi i have a 2009 58 plate zetec s tdci, 79,000 miles. was invovled in a rear end collision, damaged in the drivers rear quater and rear axle was bent, i drove it off the recovery truck and into my garden fine, left it 2 days went to start it up and it wont start. i have plugged diag into it and at first i had a fault say , theft detected car immobilized. i cleared that code and has never been back since, i then connected diag to the clocks and i am getting all these codes. b10d7 key pats not programmed geting this x3 u3006 control module imput power a, voltage to low u3006 control module input power a, voltage to high b1a68 ambient air temperature sensor circuit b1b71 evaporater temperature sensor u0151 lost communications with restraints control module uo121 lost communication with abs control module car had no airbag damage.

Submitted: 5 years ago.
Category: Ford