How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gallagher99 Your Own Question
Gallagher99
Gallagher99, Senior Vehicle Technician
Category: Ford
Satisfied Customers: 3441
Experience:  SVQ LEVEL 3, QAULIFIED FORD SENIOR TECHNICIAN , ATA REGISTERD ,12 YEARS EXPERIENCE
17855046
Type Your Ford Question Here...
Gallagher99 is online now

My ford connect keep cutting out and going into limp mode i

This answer was rated:

my ford connect keep cutting out and going into limp mode
i have had a new high pressure pump and fuel filter but it still keeps cutting out please help ?

Hi there , good evening to you and sorry for the delayed response

My name is ***** ***** I would be happy to assist you tonight

Ok have you had a diagnostic fault code check carried out as of yet if so what fault code is being logged in the pcm

Kindest regards ***** *****

Brian

Customer: replied 5 months ago.
Hi Brian
the codes i have got are
P1204/ODDTCs (CYLINDER NO 4 INJECTOR CIRUIT OPEN/SHORTED)
U0001/ODDTCs (HIGH SPEED CAN (CONTROLLER AREA NETWORK)COMMUNICATION BUS)
P0625/ODDTCs (GENERATO FIELD TERMINAL CURCUIT LOW)
P1201/ODDTCs (CYLINDER NO,1 INJECTOR CIRCUIT OPEN/SHORTED)
P0645/ODDTCs (AIR CONDITIONING CLUCH RELAY CIRCUIT)PLEASE HELPregards Richard

Hi Richard thanks

Ok if these are the codes which are repeatedly appearing after flinging into limp mode

Then you will need to replace the injectors in cylinders 1 & 4

This is a common occurrence on older 1.8tdci lynx engines

What I normally do is erase all the codes (just incase someone has ie disconnected a multiplug from a previous repair ) as this can leave a code which can cause mis diagnosis

I then carry out a fresh fault code check when fault reoccurs

If this has been done and you are getting cylinder 1&4 injector short circuit I would replace both these injectors

(These don’t need to be programmed into the pcm after fitting ) but I advise a new leak off pipe o ring and clip be fitted at the same time as injector replacement

If you need further help or technical assistance on this issue going forward Richard

please let me know and I will do my upmost to assist you

If you are satisfied with my answer /advice thus far

PLEASE REMEMBER TO RATE MY ANSWER as this helps to build my online profile and is how Iam accredited

Kindest regards ***** ***** and have a nice evening

Any positive feedback / bonuses are kindly appreciated

Kindest regards ***** *****

Brian

Customer: replied 5 months ago.
Hi BrianThank you I'll try that and if i have any other problem I'll email thank you againregards Richard

Hi Richard no worries

I have resolved many 1.8tdci injector issues like yours by replacing the injector/s

If you need further help or technical assistance on this issue going forward Richard

please let me know and I will do my upmost to assist you

If you are satisfied with my answer /advice thus far

PLEASE REMEMBER TO RATE MY ANSWER as this helps to build my online profile and is how Iam accredited

Kindest regards ***** ***** and have a nice evening

Any positive feedback are kindly appreciated

This post will stay open even after rating is given when prompted

Kindest regards ***** *****

Brian

Gallagher99 and other Ford Specialists are ready to help you